Rover XQE 100 380 - DND Services Ltd

Home

Latest News

About Us

Decode

Other manufacturers...

DND Services Ltd :: Database :: Decode - Instant Radio Code Service :: Rover XQE 100 380

Rover XQE 100 380

7 640 263 342 (USA 5 Digit Code)

Radio Code & Decoding Service

Rover XQE 100 380
Blaupunkt 7 640 263 342

As originally fitted to the :

Rover 25
Rover 45

Please note that code entry is only possible when "CODE ----" is shown in the display. If the unit is codelocked it will need to be left switched on up for up to two hours to reset before another code entry attempt is possible. If it does not reset after this time, then all of your code entry attempts may have been used up, and the unit will need to be sent to us to be decoded and reset. Please contact us for the cost of this service.

If you have lost your radio code, the Security Code for this Radio is available NOW using our fully automated INSTANT RADIO CODE service. Once your Radio details have been submitted, your Code will be ready - Instantly !! - No Waiting !!

To remove the Radio, you will need to open the two small flaps either side of the fascia, and this will reveal two allen keyed screws that are holding the unit in. Using a 2.5mm Allen Key or a Torx T10, unscrew the bolts counter clockwise until a small resistance is felt. The bolts will not come out, but are moving a sliding bar at the side of the radio. Once a slight resistance has been felt, the radio can be withdrawn. The leads are often very fiddly to remove and require the plastic housing at the rear plug to be slid in an upwards direction to unlock the clip holding the plug in. This is often very tight.

USA Models:

Please note that this decode service will provide a four digit code that is widely used around Europe. Certain countries, including the USA were reprogrammed when they left the factory with a five digit security code. If you select the USA version from the menu when prompted, a solution will be provided for those requiring a 5 digit code.

Please Note:

Your USA Radio with a 5 digit code needs
to be programmed using the 4 digit code
provided by following the procedure below.

Code Entry as Follows:

Switch on ignition
Switch Radio On - Display Shows
" CODE - - - - - "
Press and Hold “M” for six seconds
Until display shows “AREA + Your Country”
Press preset " 1 " repeatedly
To toggle through the regions
USA – CANADA – OC + RDS – JAPAN - EUROPE
Select “AREA EUROPE”
Turn OFF Radio
Switch Radio On - Display Shows
" CODE - - - - "
Enter your 4 digit code
Press preset " 1 " repeatedly for 1st Digit
Press preset " 2 " repeatedly for 2nd Digit
Press preset " 3 " repeatedly for 3rd Digit
Press preset " 4 " repeatedly for 4th Digit
If the correct code number is now shown
Press RH Tuning Button " > " To Enter
Radio is now on
Press and Hold “M” for six seconds
Until display shows “AREA EUROPE”
Press preset " 1 " repeatedly
To toggle through the regions
USA – CANADA – OC + RDS – JAPAN - EUROPE
Select “AREA + Your Country”
Turn OFF Radio

Radio can now be used as normal

Details