Vauxhall CAR 400 - DND Services Ltd

Home

Latest News

About Us

Decode

Other manufacturers...

DND Services Ltd :: Database :: Vauxhall CAR 400

Vauxhall CAR 400

DC396/75 90.462.500

Philips Radio / Cassette as fitted to a wide range of Vauxhalls.

Please note that code entry is only possible with the ignition switched on, and in the order shown below. If the display shows a number less than 10, and the word SAFE, then the unit may be codelocked. If this is the case, leave it switched on for up to two hours and a further attempt at code entry should be possible. We are able to decode and reset this radio if you send it to us.

To remove the Radio, you may need to remove four small Allen Key screws in the front panel before the removal tools can be inserted through the holes. Once the removal tools are inserted, push in until a click is felt, and then withdraw the radio. The cage and leads will probably remain fixed to the car.

Removal Tools Required : PC5-83

If you intend replacing this Stereo with an Aftermarket one, you may need the following:

PC2-04-4 Vauxhall to ISO Adaptor Lead
PC9-350 Vauxhall with Trafficmaster to ISO Adaptor Lead
PC9-106 Vauxhall Steering Interface for Sony Models
PC9-706 Vauxhall Steering Interface for Kenwood Models
PC9-806 Vauxhall Steering Interface for Pioneer Models
PC5-27 ISO to DIN Aerial Adaptor Lead

Accessories Available for this Radio:

TA-001 Mounting Cage
PC3-304 Vauxhall Power Cord / Repair Loom Assembly

Programming Hints:

There are two versions of Vauxhall vehicle displays, one with 8 Digits and one with 10 Digits. If you connect this stereo to the wrong display, code entry is possible, but the display will either freeze or dissappear. Turn off Radio, Press and Hold Presets "4" & "6" at the same time to toggle between the two display modes.

Code Entry as Follows:
Turn Off Stereo
Switch On Ignition (No Need To Start Engine)
Press & Hold Preset " AS " and
Switch Radio On - Display Shows
" SAFE " And Then Shows " 10 - - - - "
Press preset " 1 " repeatedly for 1st Digit
Press preset " 2 " repeatedly for 2nd Digit
Press preset " 3 " repeatedly for 3rd Digit
Press preset " 4 " repeatedly for 4th Digit
If the correct code number is now shown
Press & Hold Preset " AS " Until the Unit Beeps

Details